over coating
英 [ˈəʊvə(r) ˈkəʊtɪŋ]
美 [ˈoʊvər ˈkoʊtɪŋ]
网络 顺毛呢
双语例句
- Apply on properly blast cleaned steel or directly over inorganic zinc coating in good condition.
施工于适当处理的钢材表面上，或直接施工于状态良好的无机富锌涂层之上。 - Optimal Chip Changing Tactics in Depositing Process of Multiplayer Optical Coatings FEM Simulation of Strip Edge Over Coating During Hot-Dip Galvanizing
多层膜镀制过程中监控片的最优化更换策略热镀锌过程边部过镀锌的有限元仿真 - In order to achieve better protection, the surface of the over pottery antiseptic bottom coating described is also coated with the over pottery antiseptic faced coating.
为了达到更好的保护效果，所述超陶防腐底漆表面还涂覆有超陶防腐面漆。 - In the leaky ray zone of a normal core-clad-coating optical fiber, the liquid is perturbed from a pressure nozzle and deposited over the fiber, replacing coating.
在标准的纤芯-包层-涂敷层传感光纤的光线泄漏区，液体通过压力管口被喷射到光纤上作为涂敷层。 - The explanation is given to the importance of the quality control over anticorrosive coating of oil and gas pipeline.
本文论述了油气输送管道防腐涂装质量控制的重要性； - This induces partial evaporant ionisation, providing uniform ion-assisted deposition over extended coating areas.
这会诱发部分蒸发剂电离化，使得电子辅助成膜统一化。 - Gas-Phase Epoxidation of Propylene with Hydrogen Peroxide over Titanium Silicalite Catalyst Study on the Property of Aerosil in Epoxy Oxygen and Rich Zinc Coating
丙烯和双氧水在TS-1上气固相环氧化反应气相二氧化硅对环氧富锌涂料性能的改性研究 - Catalytic Oxidative Dehydrogenation of Isobutane over Zinc Molybdate SPRAY COATING OF MOLYBDENUM
异丁烷在钼酸锌上的催化氧化脱氢 - The adhesive strength between the coating and the matrix, measured by bond_pull method, is over 18 MPa. The surface and cross section morphology of the coating were observed by SEM.
采用粘结拉伸法测定的涂层与基体结合强度大于18MPa，用SEM观察涂层表面及断面的形貌，可见涂层表面较为平整，没有明显的裂纹； - Advantages of PHT coated products over other coating paste are low coefficient of heat transfer, high radiant rate of far IR and excellent ther-mal insulation effect.
用该浆生产的涂层纺织品传热系数小、远红外辐射率高、隔热保暖效果好。 - Ni based CNTs composite coating was prepared by electroless plating, which had amorphous microstructure and exhibited much higher wear resistance over traditional composite coating.
用化学镀方法制备的镍基碳纳米管复合镀层比传统的复合镀层具有更高的耐磨性能，结构为非晶态。 - Discussion Over Forming Process of Charring Layers of Intumescent Fireproof Coating
膨胀型防火涂料炭化层形成过程的探讨 - Based on the description of formula design, preparation and property testing, of the waterproof coating made of vinyl chloride-vinylidene chloride copolymerized resin and bitumen, discussion is unfolded over the preparation of the coating and the modification of vinyl chloride-vinylidene chloride copolymerized resin.
在阐述氯乙烯偏氯乙烯共聚树脂沥青防水涂料的配方设计、制备工艺及其性能测试的基础上，讨论了该防水涂料的制备工艺及氯乙烯-偏氯乙烯共聚树脂的改性作用。 - Tribological performance investigation of the WC-Co coating and MoCr coating proves that the abrasive resistance of the WC-Co coating is over 10 times higher than that of the MoCr coating under the condition of water lubrication.
对WC-Co涂层和MoCr铬镀层的摩擦学性能研究表明：在水润滑条件下，WCCo涂层的耐磨性是MoCr铬镀层的10倍以上。 - It indicates that the gradient layers coating has many advantages over the single layer coating in preventing the substrate from plastic deformation and reducing the interface stresses.
表明梯度层在改善膜层与基体界面的应力分布及减小基体中的塑性变形区方面比单覆层有明显优点。 - In order to effectively solve high power CO 2 laser's HR-coating infrared output-coupler absorbing laser energy generate thermal effect problem, over coating parameters and working characteristic analysis, the infrared output-coupler thermal model is built.
为了有效地解决高功率CO2激光器高反膜红外耦合窗吸收谐振腔内激光能量产生热效应问题，通过对红外耦合窗镀膜参数和工作特性分析，建立了红外耦合窗热模型。 - The technical advantages of vacuum plasma spray over conventional chemical vapor deposition ( CVD) and air plasma spray in tungsten coating were also discussed.
和CVD方法以及常压等离子体喷涂方法制备的钨涂层相比，低压等离子体喷涂具有明显的优势。 - Stealth technology is a high technology of the national defense focused by countries all over the world. Kadar absorbing coating is one of the important parts in the field of stealth technology. The mechanism and technical requirement of radar absorbing coating are described.
隐身技术是当今各国重点发展的国防高科技技术，其中雷达吸波涂层RAC（RadarAbsorbingCoating）是实现隐身技术的重要组成部分。 - But a more compact film with higher loading and larger size of TiO2 but lower specific photocatalytic efficiency ( ethylene conversion over unit mass TiO2 and unit area of TiO2 film) was obtained by EPD compared with dip coating method.
但由于电泳膜有较高的TiO2沉积量、且结构致密、TiO2的粒径较大，其比活性（单位面积上单位质量TiO2的光催化活性）却比提拉膜的低。 - The preparation technology was optimized by orthogonal experiment, and it was found that as coating ratio was 1 0 kg/ m 2, the fireproof time was over 2 h, which proved that the coating could be used as ultra filmy steel structure fireproof.
用正交优化工艺制备的防火涂料，涂覆比10kg/m2时，耐火时间超过2h，可作超薄型钢结构防火涂料使用。 - After the development of over one hundred years, automotive coatings have developed from single-layer coating with single function to multi-layer coating with a variety of functions.
经过百余年的发展，汽车涂层从只具有单一功能的单层涂层发展成为了具有多种功能的多层涂层。 - Scratch process may be divided into three phases, i.e. a stylus tip indenting coating surface, the stylus tip slipping on coating surface and the stylus tip rising over coating surface.
划痕过程可以分为划针尖端压入涂层表面、划针在涂层表面上滑动和划针升高等三个阶段。 - With the increasing oxidation time, the coating thickness increases accompanied with the more compact inner layer. While, the over growth of the coating into the substrate at the local sites leads to the formation of more rough interface between coating and substrate.
随着氧化时间的延长，涂层厚度逐渐增加，内层变得更加致密，但由于涂层向局部基体过度生长，导致涂层与基体的结合面逐渐变的凹凸不平。 - Over the years, through a variety of preparation methods ( such as doping, surface coating, etc.), many researchers tried to change its structure to enhance stability and electrochemical properties.
多年来许多科研工作者通过多种制备方法途径（如掺杂、表面包覆等）来改变其结构以提高稳定性和电化学性能。 - Over the last decade, some units designed and developed a lot of software systems on material corrosion, failure and evaluation, but none of them has been seen for developing a coating performance evaluation and management software system.
近十几年来，国内一些单位设计和开发了不少关于材料腐蚀、失效及评价预测的软件系统，但目前尚未见到针对涂层服役性能的评价及管理软件的相关报道。 - Over the years, people make use of many surface engineering technologies to improve the corrosion resistance of the coating, but there are some limitations.
多年来，人们通过许多表面工程技术来改善其耐腐蚀性，但都存在一些局限性。 - For the coating system, the current distribution results of the WBE show that the high anode current existed at the defect of the coating, the cathodic current dispersed over the coating.
对于涂层体系，阳极电流出现在涂层的缺陷处，阴极电流被整个涂层平分。